The Experimental Investigation of Springback in Titanium Grade 1 Sheet Material and Prediction by Fuzzy Logic
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2017, Vol 5, Issue 3
Abstract
In this study, the springback phenomenon of Titanium Grade 1 sheet metal which is observed after V bending operations in room temperature was investigated experimentally. Bending angle, punch radius and holding time are determined as experimental study parameters. Also, the springback angles were predicted by using fuzzy logic system for non-performed experiment parameters. It was observed that a 15 degree increase in die’s angle increased the springback by an average 0.62 degree, a 2 mm increase in punch’s radius increased the springback by an average 0.14 degree, and a 10 second increase in holding time decreased the springback by an average 0.12 degree. A 93.3 % similarity was found when the results from the actual experiment and the estimations made with the fuzzy logic method were compared. It is observed that the fuzzy logic method can be used successfully for springback estimations.
Authors and Affiliations
Tahsin ÖNEL, İbrahim KARAAĞAÇ
Keywords
Related Articles
- EP ID EP484359
- DOI -
- Views 117
- Downloads 0
The Investigation of viscosity values of Aluminum Powder Reinforced Polypropylene.
In this study, aluminum (Al) powder reinforced polypropylene based composites were produced and viscosity changes were investigated for the determination of flow properties of composites. Experiments have been carried ou...
Effective Capacity Performance of α-κ-μ Fading Channels
In this work, a closed-form expression is derived for effective capacity of α-κ-μ fading channels. Then, an asymptotic expression is also proposed for the effective capacity of the considered channel model. In addition,...
The Effect of Cutting Parameters on Machinability in Turning of Duplex 1.4462 Stainless Steels
In this study, effects of cutting parameters and cutting tool formation on machinability were examined in Dublex 1.4462 stainless steel in turning which is increasingly used due to its high mechanical properties. Experim...
Q-Switching in Micro Manufacturing by Laser
Q-switching is a method to create high power- short pulses in laser material processing. Although fifty years passed after the development of this method, it is still used especially in the new developed fiber laser devi...
Tent Map based Optimization Method
In the real life, some problems cannot be solved using mathematical methods. Meta-heuristic optimization methods are usually used to solve these problems. One of the solutions used to increase the performance of meta-heu...