THE STUDY OF MOLTEN ZINC INTERACTION ON THE SURFACE OF REFRACTORIES IN THE PRODUCTION OF ZINC OXIDE
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2013, Vol 20, Issue 2
Abstract
This paper is closely connected with the complete process of indirect production of ZnO as well as with the problems which occur during the metallurgical process. Purity of raw materials has an important influence on the final quality of ZnO and the occurrence of slag that remains stuck on the walls of furnace linings. ZnO is generally produced in the melting furnaces with different types of ceramic linings. Input materials have to be analyzed and investigated in the order to the predict behavior from the aspect of the complex production process. Moreover, analysis of occurrence of undesirable phases in the batch, the output materials, character of furnace linings and waste material have to be evaluated and observed. Mutual interaction of all components will have a significant impact on the final quality of the ZnO. The result of the investigation of interaction occurring in the components will be used for the proposal of the suitable surface for furnace lining while the mentioned result is mainly obtained on the principle of chemical reactions and bonds. This surface for lining should have a minimum adhesion of the zinc and its alloys relating to production of ZnO.
Authors and Affiliations
Natália Luptáková, Evgeniy Anisimov, Irena Janotová, Peter Švec, Františka Pešlová
Keywords
Related Articles
- EP ID EP130605
- DOI -
- Views 96
- Downloads 0
Influence of the surface finishing on the corrosion behaviour of AISI 316L stainless steel
The influence of the surface preparation of AISI 316L stainless steel by mechanical grinding, polishing and following passivation was examined by immersion corrosion tests in solution simulating body fluids. Decreasing o...
COMPUTER CONTROLLED INVESTIGATION OF SURFACE AND BULK PROCESSES IN MG-BASED ALLOYS DURING HYDROGEN ABSORPTION
Different Mg-based alloys were tailored and prepared to investigate the surface and bulk processes during hydrogen absorption. Volumetric-, resistance-, XRD-, optical-, and mass measurements were carried out. Heat treatm...
DEGRADATION OF 0.5Cr-0.5Mo-0.25V STEEL MICROSTRUCTURE DURING EXPLOITATION
Degradation of 0.5Mo-0.5Cr-0.25V material after long-term high-temperature service has been studied by means of microstructure and mechanical properties analysis. Samples were taken from the pipeline with steam leaking...
PRELIMINARY RESULTS IN SYNCHROTRON X-RAY DIFFRACTION MEASUREMENTS OF RUBBER COMPOSITES STRUCTURE BEFORE AND AFTER EXPOSURE TO HYDROGEN
In future years, fuel cells are expected to represent a promising technology as a source of heat and electricity in buildings and of electrical power for vehicles, since fossil fuels are exhausting and significantly degr...
THE EFFECT OF REFLOW ON WETTABILITY OF Sn 96.5 Ag 3 Cu 0.5 SOLDER
Surface conditions on Printed Circuit Board (PCB) final finishes have an important impact on the wetting behavior with lead-free solder. The improvement of the wettability in liquid Sn 96.5 Ag 3 Cu 0.5 Solder alloy on PC...