The testing of the tensil strenght concrete at bending
Journal Title: International Journal of engineering Research and Applications - Year 2017, Vol 7, Issue 7
Abstract
The theme of this paper is the behavior analysis of the concrete girders classically armored with the addition of mineral wool fibers. The author made five sets of concrete girders of the same geometric characteristics: 12x20x250 cm and twelve concrete elements (cubes and prisms). The following parameters were tested: the strength of the classically armored concrete with the addition of mineral wool fibers, the concrete ductility and the control of cracking. The girders were loaded with the variable force: 2x5kN to 2x19 kN at the short time load after 28 days from the day of their making and at the long time load , during 365 days. The influence of the concrete , armored by the fibers mineral wool , reflected to the concrete strength at bending 16,5% .
Authors and Affiliations
Novica Toncev
Keywords
Related Articles
- EP ID EP391915
- DOI 10.9790/9622-0707097275.
- Views 100
- Downloads 0
Review On “Dietary Fiber Incorporated Dairy Foods: A Healthy Trend”
Dietary fiber is not a „nutrient‟, it is nevertheless an important component of our diets. The fact that it passes through the body without being absorbed is the main reason why fiber is so important. Dietary fiber or „r...
Structural Changes in the Surface Layer of Deep Rolled Samples Due to Thermal Loads
Deep rolling processes initiate plastic deformations in the surface layer. The local characteristics of deformation are dependent on the induced stress expressed by the local stress tensor. Equivalent stresses above yiel...
Experimental Investigation of Emission Characteristic of Tert Butyl Alcohol and Gasoline Blend Using Two Stroke Si Engine
Internal combustion engine are the mostpreferred prime mover across the world. Spark ignition engine is preferred locomotive prime mover due to its smooth operation and low maintains. The gasoline is fossil fuel which is...
Successive Blind Interference Alignment Using Reconfigurable Antenna
Interference alignment is new interference mitigation technique. In latest studies many experiments evolutions are proved only for interference alignment. But very less have given attention to the blind interference alig...
A Dynamic Model Of Synchronous Machine
Synchronous electrical machines usually have three phase variable current winding in stator, direct current excitation winding in rotor and short closed loop distributed damping winding in rotor. The power of synchronous...