THREE-ELEMENT BOGIE SIDE FRAME STRENGTH
Journal Title: Наука та прогрес транспорту - Year 2017, Vol 0, Issue 1
Abstract
Purpose. To evaluate the effect of different loads on the stress-strain state of the freight car bogie side frame, as well as to evaluate the distribution of the stress fields in the design of the freight car bogie side frame supported through the horizontal surface and through the horizontal and inclined surfaces of the pedestal opening. Methodology. A volumetric finite element model of the side frame of ZK-1 bogie of the freight car was designed. The forces under the current regulatory documentation for theoretical research were applied to the model, the stress arising in the model elements were determined. The static tests of ZK-1 bogie side frame were conducted; they allowed determining the stresses in the key points of the frame under the action of forces in accordance with the existing procedure of static tests of the freight car bogie side frame. To check the quality of the finite element model we determined the stress in the model under the action of forces corresponding to the static requirements. The corresponding coefficients were determined to match the stress obtained through theoretical studies and static tests. The results of theoretical and experimental studies of stress for dangerous sections of the side frame design were compared. Findings. The regulatory documentation for carrying out experimental research of the side frame strength does not fully take into account the load acting on the frame during its operation and that provided while assessing the side frame strength theoretically. The strength evaluation of the side frame by the results of field tests only does not give a complete picture of the distribution of stress fields, as the provided sensor installation points do not cover most of the design elements with possible stress concentration. Originality. The loads applied to the side frame during theoretical and experimental studies were compared to the loads acting during operation. The impact of use of inclined surfaces in the pedestal box opening was evaluated. Practical value. The obtained results allow the more accurate assessment of the three-piece bogie side frame strength, as well as allow you to choose the more preferred method of side frame support in the axle box.
Authors and Affiliations
O. A. Shykunov
Keywords
Related Articles
- EP ID EP228254
- DOI 10.15802/stp2017/92535
- Views 88
- Downloads 0
ВЛИЯНИЕ ХИМИЧЕСКОГО СОСТАВА ЧУГУНА НА МЕЖФАЗНОЕ РАСПРЕДЕЛЕНИЕ CR ПОСЛЕ ОТЖИГА ПРИ 690 °С
Цель. В научной работе необходимо установить влияние химического состава Fe–C–Cr–Mn–Ni чугуна на содержание хрома в металлической основе, карбидах, а также коэффициент межфазного распределения хрома после отжига при 690...
SELECTION OF CONSTRUCTIVE SOLUTIONS OF CAR ELEMENTS WITH SMALL EMPTY WEIGHT
Purpose. The work is aimed to identify the reasons for the significantly higher coefficient of the empty weight of 1520 mm gauge cars in comparison with the freight cars in North America and to give recommendations for r...
MODELING THE TRANSITION CURVE ON A LIMITED TERAIN
Purpose. Further development of the method of geometric modelling of transition curves, which are placed between rectilinear and circular sections of railway tracks and are created in localities, the relief of which caus...
ЧУТЛИВІСТЬ НАПРУЖЕНЬ ДО СИЛ, ЩО ДІЮТЬ НА ЛИТІ ДЕТАЛІ ВІЗКІВ ВАНТАЖНИХ ВАГОНІВ
Мета. Визначити вплив компонентів сил, які діють у буксовому вузлі та центральному ресорному ступені підвішування, на напруження, що виникають у бічній рамі трьохелементного візка, – основна мета наукової роботи. Методик...
WASTEWATER TREATMENT OF INDUSTRIAL ENTERPRISES BY THE NATURAL METALS
Purpose. The paper deals with the galvanic coupling effect (time of treatment and other factors) on the removal of oil, synthetic surface active substances (SSAS), chromium, etc. from waste process solutions used in meta...