TRIBOLOGICAL PROPERTIES OF COMPOSITE COATINGS ON ALUMINIUM ALLOY PARTS FOR TRANSPORT MEANS
Journal Title: Tribologia - Year 2017, Vol 272, Issue 2
Abstract
The present paper describes the structure, surface topography, and tribological properties of a DLC composite coating produced by magnetron sputtering on an engine cylinder liner AC-AlSi12NiCuMg (AC-47000) cast alloy as well as on AW-A6061 aluminium alloy matrix W6.A15A composite (AW-6061+10Al2O3P) used for the production of oil-less air compressor cylinders and car roof sliders. The DLC coating slid against a TG15 sliding composite under dry friction, which is an equivalent to the friction system for oil-less air compressors and against cast iron under limited lubrication conditions (boundary lubrication). The limited lubrication conditions are dominant during the starting of a cold combustion engine, when the viscosity of oil is too high and the splash lubrication is not sufficient. The DLC coatings’ properties are compared with the anodic hard coatings (AHC) and composite coating with an AHC matrix applied in sliding contacts presently used. The wear of composite TG15 during sliding against DLC was higher than during sliding against AHC. The DLC coating can replace the anodic hard coating and composite coatings on its matrix presently used in sliding contacts.
Authors and Affiliations
Andrzej POSMYK
Keywords
Related Articles
- EP ID EP239723
- DOI -
- Views 61
- Downloads 0
THE INFLUENCE OF THE CONDITIONS OF INVESTIGATIONS ON TRIBOCORROSION OF STEEL AISI 304 IN SOLUTION OF 0.5 M H2SO4
The paper presents the results of tests of tribocorrosion wear of stainless steel AISI 304 in solution of 0.5M H2SO4. The experiments were carried out on a technical stand with a model pair type pin-ondisc. The stand was...
OPTIMUM NET FOR NUMERICAL REYNOLDS SOLUTIONS IN TRIBOLOGY
The main scientific topic of the presented paper concerns the method of the determination of the optimum net for numerical solutions of partial recurrence Reynolds equations occurring in the hydrodynamic theory of lubric...
BADANIE WŁAŚCIWOŚCI ŻELIWA SFEROIDALNEGO STOPOWANEGO LASEROWO
Zwrócono uwagę na możliwości wykorzystania stopowania laserowego borem w odniesieniu do elementów wykonanych z żeliwa. Zaprezentowano wyniki badań pozwalające na wytworzenie ciągłej warstwy na powierzchni zewnętrznej tul...
TRIBOLOGICAL PROPERTIES OF HVOF SPRAYED NANOSTRUCTURED COMPOSITE COATINGS
This paper concerns the results of investigations on a nanostructured WC12Co HVOF sprayed composite mixed with nanostructured Fe3O4. The microstructure and composition of nanostructured powders and coatings were analysed...
Struktura geometryczna powierzchni boku zęba kół zębatych a proces zmęczeniowego zużywania powierzchniowego
W pracy rozpatrywane są parametry struktury geometrycznej powierzchni boku zębów kół zębatych, ukształtowanej w końcowej fazie procesu technologicznego oraz ich wpływ na zmęczeniową wytrzymałość powierzchniową. Badaniom...