Wear Characteristics of Multilayer-Coated Cutting Tools in Milling Wood and Wood-Based Composites
Journal Title: Tribology in Industry - Year 2016, Vol 38, Issue 1
Abstract
This article presents the characteristic of wear on the clearance face of newly multilayer-coated K10 cutting tools when cutting mersawa wood, fiberboard, particleboard, and glass reinforced concrete (GRC). The K10 cutting tools were coated with monolayer titanium aluminum nitride (TiAlN), multilayer TiAlN/titanium silicon nitride (TiSiN), and TiAlN/titanium boron oxide nitride (TiBON). Cutting tests were performed on computer numeric control router at a high cutting speed of 17 m/s and a feed rate of 0.2 mm/rev to investigate the wear characteristics on the clearance face of these coated tools. Experimental results show that the coated tools experienced a smaller amount of clearance wear than the uncoated tool in cutting the mersawa wood, fiberboard, particleboard, and GRC. The GRC compared to the other work materials caused higher amount of clearance wear for both the uncoated and coated cutting tools. High content of silica and density were the reason for this phenomenon. The best coating among other coated cutting tools in this study was multilayer TiAlN/TiBON. The high hardness, low coefficient of friction, high resistance to oxidation, and high resistance to delamination wear of the multilayer-coated TiAlN/TiBON tool indicate a very promising applicability of this coating for high-speed cutting of abrasive woods and wood-based materials.
Authors and Affiliations
F. Fahrussiam , I. A. Praja , W. Darmawan , I. Wahyudi , D. Nandika , H. Usuki , S. Koseki
Keywords
Related Articles
- EP ID EP106845
- DOI -
- Views 140
- Downloads 0
Wear Micro-Mechanisms of Composite WC-Co/Cr - NiCrFeBSiC Coatings. Part I: Dry Sliding
The influence of the cermet fraction in cermet/ metal composite coatings developed by High-Velocity Oxyfuel Flame (HVOF) spraying on their tribological behaviour was studied. Five series of coatings, each one containing...
Wear Analysis of Top Piston Ring to Reduce Top Ring Reversal Bore Wear
The piston rings are the most important part in engine which controls the lubricating oil consumption and blowby of the gases. The lubricating film of oil is provided to seal of gases towards crankcase and also to give s...
Evaluation of Electroless-Nickel Plated Polypropylene under Thermal Cycling and Mechanical Tests
The electroless-nickel composite (ENC) consisting of bright metallic electroless-nickel (EN) and dull electroless-nickel-phosphorus (EN-P) were deposited on the polypropylene (PP) substrate from the sodium hypophosphite...
Emission and Friction Analysis of IC Engine Running in Methanol Blend
Emission and friction are considered to be the significant contributors towards engine parasitic losses. Inherent engine design responsible for such irregularities is difficult to eliminate totally, as millions of engine...
Influence of Gas Flow Rate on the Deposition Rate on Stainless Steel 202 Substrates
Solid thin films have been deposited on stainless steel 202 (SS 202) substrates at different flow rates of natural gas using a hot filament thermal chemical vapor deposition (CVD) reactor. In the experiments, the variat...