A New Multilevel Inverter Topology of D-STATCOM to Compensate Reactive and Nonlinear Loads

Abstract

This work proposes an enhanced hybrid distribution static compensator (D-STATCOM) topology to address some practical issues like power loss, filter size, performance etc. A LCL filter has been utilized at the front end of a voltage source inverter (VSI), which gives better exchanging harmonics elimination while utilizing much littler estimation of an inductor as contrasted and the conventional L channel. A capacitor is utilized in as eries with LCL channel to diminish the dcinterface voltage of the D-STATCOM. This thusly lessens the power rating of the VSI. With lessened dc-connect voltage, the voltage over the shunt capacitor of the LCL filter will be additionally less. It will decrease the power misfortunes in the damping resistor as contrasted and the conventional LCL filter with latent damping. In this way, the proposed DSTATCOM topology will have decreased weight, cost, rating, and size with enhanced proficiency and current pay capacity contrasted and the conventional topology. A deliberate methodology to outline the segments of the inactive filter has been displayed. A multilevel cascaded-H-bridge is executed in the VSI operation of a D-STATCOM topology. The viability of the proposed DSTATCOM topology over customary topologies is approved through MATLAB/SIMULINK programming.

Authors and Affiliations

Mattaparthi Suresh| M.Tech Student, Department of EEE, KIET, kakinada, India, K Dhana Raju| Asst. Professor, Department of EEE, KIET, Kakinada, India

Keywords

Related Articles

Moisture Susceptibility on Asphalt Mix and the Effect of AntiStripping Additives

The damage due to moisture can be result in asphalt pavements either due to stripping or the softening of asphalt, both of which result in loss of ability to resist traffic- induced stresses which is mainly occur due...

To demonstrate overlay routing using BPG routing, TCP improvement, and VOIP applications

If we are just concerned in getting better routing properties among a single source node and a single destination, then the dilemma is not intricate, and judgment the optimal number of nodes becomes in significant be...

An Effective Utilization of Concentrated Solar Energy

This thesis describes a new Concentrating Solar Energy with Integral thermal storage that is applied in a solar thermal power station. Solar radiation is concentrated on the boiler of a conventional power station by t...

UPQC Implements The 3-Phase Shunt And Series Active Power Filter To Compensate Current And Voltage Harmonics

This paper presents the three phase shunt and series active power filter in order to reduce the current and voltage harmonics. To implement Unified Power Quality Conditioner (UPQC) control algorithm two control strat...

Configuration as well as Performance of an On-Chip IncarnationArrangement for Multiprocessor System-On-Chip

The novel on-chip coordinate in silicon indicated course of action to fortify ensured development change in multiprocessor SOC applications. A pipelined circuit-exchanging Employed in the proposed structure with FIFO...

Download PDF file
  • EP ID EP16874
  • DOI -
  • Views 349
  • Downloads 7

How To Cite

Mattaparthi Suresh, K Dhana Raju (2017). A New Multilevel Inverter Topology of D-STATCOM to Compensate Reactive and Nonlinear Loads. International Journal of Science Engineering and Advance Technology, 5(1), 134-140. https://www.europub.co.uk/articles/-A-16874