ADDITIVES INFLUENCE ON THE PROCESSING CHARACTERISTICS OF REFRACTORY MIXTURES
Journal Title: Metallurgical and Mining Industry - Year 2018, Vol 10, Issue 2
Abstract
In this publication, the authors report on improving processability of concrete mixtures and the quality of monolithic linings for thermal metallurgical units and constructions. The certain result have been achieved with the introduction of expanded pearlitic sand as the additive of the mixtures thereof: the compositions of refractory mixtures with the additives of pearlitic sand (0.1%-1.8%) have been developed in order to permit both required placeability and structural strength of the mixtures. The work produced has allowed revealing the lamellar sliding effect which occurs with the grains of the filling between the pearlite layers. This effect provides the opportunities of both better placeability and structural strength of the mixture. In its turn, the better quality of monolithic linings is achieved.
Authors and Affiliations
A. Y. Konoplianyk, I. M. Iliev
Keywords
Related Articles
- EP ID EP563020
- DOI -
- Views 134
- Downloads 0
Strength of liquid glass ceramic shell mold
Objective is to establish how the layers drying regime and the composition of refractory slurry when using coarse dusting quartz sand as the cushioning layer influence the strength of not pre-calcinate and calcinate liqu...
Justification of environmental technologies and means for dust control of tailing dumps surfaces of hydrometallurgical production and concentrating plants
Objective of paper consists in research and development of environmental technologies and means of dust control of tailing dumps surfaces of hydrometallurgical production and concentration plants by binding tailings with...
Determination of spatial position of spindles at elongating mill TPA 5-12″ with pilger mills during rolling-off of large-size bottles
The paper presents and gives solution to the problem of determining optimal geometric parameters of the deformation zone when piercing bottles on elongating mill of pilger installation 5-12″ at PJSC Interpipe NTRP. The d...
Uncontrolled parameters influence on material and energy consumption for BOF heat
The current article aims at analyzing the impact of uncontrolled parameters (the degree of СО to СО2 post-combustion, contents of silicon and carbon in iron, heat carrier specific consumption, heat loss of BOF vessel, et...
Production of billets of die-rolled section when vibratory drawing
The results of the analysis of energy-power parameters of die-rolled sections production by vibratory drawing considering kinematic parameters of process are presented. Technological process and vibratory drawing device...