Analysis of the austenitic stainless steel's r-value behavior at elevated temperatures
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2015, Vol 22, Issue 2
Abstract
An analysis of the anisotropy properties of austenitic steel AISI 304 (X5CrNi18-10) at elevated temperatures is presented in this paper. Considerations of the anisotropy problems are presented in the theoretical part of the paper, as well as the procedure for determination of the normal anisotropy coefficient. The experimental part of the paper describes the plan, methodology and equipment for testing of material's normal anisotropy and mechanical characteristics. The objective of conducting the experiments was to investigate influence of temperature on normal anisotropy, as well as on the mechanical properties of the considered material. The normal anisotropy was monitored by the coefficient – the so-called "r-value". Besides that, the tensile strength, yield stress and elongation at break were monitored, also. The tests were done on the 0.7 mm thick sheet metal within the temperature range 20 to 700 °C.
Authors and Affiliations
Dušan Arsić, Milan Djordjević, Srbislav Alexandrović, Vukić Lazić, Ružica Nikolić, Branislav Hadzima
Keywords
Related Articles
- EP ID EP148123
- DOI -
- Views 98
- Downloads 0
IMPACT STRENGTH AND FAILURE ANALYSIS OF WELDED DAMASCUS STEEL
The aim of this work was the experimental research of damascus steel from point of view of the structural analyze, impact strength and failure analyzes. The damascus steel was produced by method of forged welding from ST...
The impact of welding wire on the mechanical properties of welded joints
This paper presents results of the mechanical properties of Hardox 450 steel welded joints. These welded joints were made in accordance with welding procedure specifications (WPS), which was prepared and applied in the...
SHOT PEENING INFLUENCE ON CORROSION RESISTANCE OF AE21 MAGNESIUM ALLOY
Evaluation of the electrochemical characteristics of the AE21 magnesium alloy is presented in the article. The surfaces of tested alloys were treated by grinding and grinding followed by sodium bicarbonate shot-peening....
[sub][/sub][sub][/sub]PROPERTIES OF PLASMA AND HVOF SPRAYED COATINGS
The article compares the properties of plasma and HVOF thermally sprayed coatings obtained by blending the NiCrBSi and Fe2O3 powders. The deposition was performed by means of the Plancer PN-120 and the Diamond Jet guns f...
THE STUDY OF MOLTEN ZINC INTERACTION ON THE SURFACE OF REFRACTORIES IN THE PRODUCTION OF ZINC OXIDE
This paper is closely connected with the complete process of indirect production of ZnO as well as with the problems which occur during the metallurgical process. Purity of raw materials has an important influence on the...