Compreg - machinability during drilling
Journal Title: Annals of WULS, Forestry and Wood Technology; Zeszyty naukowe SGGW - Year 2017, Vol 97, Issue
Abstract
Compreg – machinability during drilling. The article presents the results of tests of machinability of compreg. Machinability was evaluated during drilling. The value of the axial force and cutting torque for 7 variants of feed per revolution and the quality of the drilling process were examined. Cutting forces were measured using piezoelectric Kistler sensor and Labview software. The quality was determined on the basis of digital photos taken using macro lens, two quality indices were calculated. It turned out that the assessment of machinability during drilling requires an analysis of axial force and cutting torque. One of the analyzed quality indicators observed outside the nominal diameter of the hole, was strongly dependent on feed per revolution. The impact of feed on the second indicator was much less clear.
Authors and Affiliations
Piotr Podziewski, Jarosław Górski, Karol Szymanowski, Mariusz Cyrankowski, Paweł Czarniak
Keywords
Related Articles
- EP ID EP335932
- DOI -
- Views 76
- Downloads 0
Metallocene polyolefins grafting designed for hot-melt adhesive compositions
Metallocene polyolefins grafting designed for hot-melt adhesive compositions. The hot melt adhesives based on metallocene polyolefin are frequently used for various applications, e.g. for bindings of books. The grafting...
Evaluation of maximum specific optical density for selected wood based materials using PN-EN ISO 5659:2017 method
Evaluation of maximum specific optical density for selected wood based materials using PN-EN ISO 5659:2017 method. The aim objectives of the present study is to measure maximum specific optical density under prescribed c...
Antibacterial modification of polymeric veneers by atmospheric discharge plasma
Antibacterial modification of polymeric veneers by atmospheric discharge plasma. Polyvinylchloride (PVC) veneers are widely used in many applications for modern furniture production. The research was aimed on examining t...
Antibacterial modification of polymer veneers
Antibacterial modification of polymer veneers. The increase of the resistance to infections can be achieved by plastic veneers, e.g. produced from low-density polyethylene (LDPE), surface treatment by substances containi...
Analysis of design solution the combined scissor lift
Analysis of design solution the combined scissor lift . Solving the combined transport equipment where the primary task is to pick up the material to a certain level with a subsequent movement according to the specified...