Lowering the density of dislocations in heteroepitaxial III-nitride layers: Effect of sapphire substrate treatment (review)

Abstract

In this paper, different methods for lowering the dislocation density such as incorporation of the buffer layers, substrate patterning and nitridation, silan-ammonia treatment are reviewed and compared. Advantages and limitations of these methods as well as a specific mechanism to reduce the dislocation amount are discussed. Usually, high densities of threading dislocations within the range 1010…1011 cm–2 are present in typical thin nitride films that are directly grown on sapphire substrate. Using these methods for substrate preparation, the density of dislocations can be reduced to the value 1∙107 cm–2. An important process that enables to obtain the high-quality GaN layers with the low dislocation density is patterning the sapphire substrate. The dislocation density of these substrates depends on the pattern shape and orientation of patterned strips on c-plane sapphire. Layers of GaN grown on a cone-shaped pattern have the lowest dislocation density. In addition, patterning the sapphire substrate increases the external quantum efficiency of radiative structures and reduces the mechanical stresses in the nitride layers.

Authors and Affiliations

P. V. Parphenyuk, A. A. Evtukh

Keywords

Related Articles

Domain structure regularization in monocrystalline barium hexaferrite

Conditions for regular domain structure formation in a monocrystalline barium hexaferrite plate have been studied experimentally. The purpose of the work was to develop a simple and, at the same time, an effective method...

Influence of X-ray irradiation on the optical absorption edge and refractive index dispersion in Cu6PS5I-based thin films deposited using magnetron sputtering

Cu6PS5I-based thin films were deposited using non-reactive radio-frequency magnetron sputtering. Structural studies of thin films were performed by scanning electron microscopy, their chemical composition were determined...

Optical properties of ternary alloys MgZnO in infrared spectrum

Properties of thin films of ternary alloys Mg х Zn 1–х O on the optically-anisotropic Al 2 O 3 substrates in the area of “residual rays” of film and substrate are first investigated using the method of infrared spectrosc...

New method for estimating the refractive index of optical materials in spectrally selective elements

A numerical simulation of the scattering indicatrix in optical spectral-selective cylindrical form elements has been performed. As it follows from the results of the calculations, the shape of the scattering indicatrix o...

Performance limits of terahertz zero biased rectifying detectors for direct detection

Performance limits of uncooled unbiased field effect transistors (FETs) and Schottky-barrier diodes (SBDs) as direct detection rectifying terahertz (THz) detectors operating in the broadband regime have been considered i...

Download PDF file
  • EP ID EP177809
  • DOI 10.15407/spqeo19.01.001
  • Views 111
  • Downloads 0

How To Cite

P. V. Parphenyuk, A. A. Evtukh (2016). Lowering the density of dislocations in heteroepitaxial III-nitride layers: Effect of sapphire substrate treatment (review). Semiconductor Physics, Quantum Electronics and Optoelectronics, 19(1), 1-8. https://www.europub.co.uk/articles/-A-177809