Manufacturing of Proto Type Wind Turbine Blades Using Rapid Prototype Technology
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 2
Abstract
All over the world, the wind energy has numerous benefits in helping to provide a source of clean and renewable electricity. For greater use of wind energy, the research efforts are aimed at addressing the challenge. The main objective of the project is to develop wind turbine blade model using CAD tool Autodesk inventor and Flash forge finder 3D printer for without twist and with various twist angles of 30, 60, 90, 120 and 150. 2D and 3D data can be easily integrated with Autodesk inventor software in a single digital model to create a virtual representation of the final product. The wind turbine blades are fabricated through 3D printing technology otherwise known as additive manufacturing process. The aim of this paper is to give an overview of this relatively infant technology, its diverse applications such as wind turbine industries for manufacturing prototype model to explain the development of new blade design
Authors and Affiliations
S. SELVAN NAMBI, G. M. JOSELIN HERBERT
Keywords
Related Articles
- EP ID EP347063
- DOI 10.24247/ijmperdapr201811
- Views 94
- Downloads 0
A Study on the Increasing Risks(Trauma) Related to an Ambulance for a Paramedic and Patient- A Review
This paper is to evaluate the effectiveness of pre-hospital emergency care. The objective of this review is to study how the ambulance’s transport time can be reduced. It aims to address the waiting time of the patient b...
Pre-Clinical Modeling and Simulation of Radiofrequency Ablation in Human Lung Tumor
Radio-frequency ablation (RFA) is a hyperthermia medical treatment modality, used to destroy the unwanted tissues in the human body. In this article, pre-clinical computational model has been demonstrated for attaining r...
EXPERIMENTAL ANALYSIS OF AERODYNAMIC DRAG REDUCTION OF A HATCHBACK MODEL CAR BY REAR SPOILER IN THE WIND TUNNEL
The main aim of this research is to optimize the various aerodynamic characteristics of the vehicle and to improve the fuel efficiency and vehicle performance by reducing the drag. The aerodynamic drag resistance is cons...
WEAR RATE PREDICTION OF FRICTION STIR WELDED DISSIMILAR ALUMINUM ALLOY BY ANN
The effect of process parameters on the mechanical properties of dissimilar AA6061 t6–AA5083 0 joints produced by friction stir welding was studied. Different samples were produced by varying the advancing speeds of the...
Energy Potential of Sugar-Mill Byproduct Press-Mud Through Pyrolysis Process
Press-mud is the sugar industry left-over produced from the filtration of the sugar cane juice during the production of sugar. At present, it is a good source of fertilizer and utilized in soil quality enhancement in Ind...