POLE ASSIGNMENT FOR GLASS CAPILLARY TUBE DRAWING PROCESS BY USING MATLAB AND MAPLE LANGUAGE
Journal Title: Applied Engineering Letters - Year 2016, Vol 1, Issue 3
Abstract
The question of pole placement for glass capillary tube drawing process is considered. It is used a frequency domain approach to an arbitrary finite spectrum assignment for multivariable time delay systems in order to control glass capillary tube drawing process. The Padé approximation is used for the system of third order and time delay is eliminated from the transfer function of the process. The responses are shown as well the transfer function of the closed loop after applying finite spectrum method. By choosing state variables it is obtained non degenerative transfer function of process model. The time delays in open loop remained the same as in the closed loop. The all poles are located in the left half plane and system is stable. Appropriate program support for this type of problems is developed in Maple language
Authors and Affiliations
Djordje Dihovicni
Keywords
Related Articles
- EP ID EP211881
- DOI -
- Views 91
- Downloads 0
OPTIMIZATION OF EFFICIENCY OF WORM GEAR REDUCER BY USING TAGUCHI-GREY METHOD
In this paper the efficiency and output power are considered, as the most important characteristics of the worm gear reducer, and their optimization was performed. As the influencing factors, the viscosity of the lubrica...
INFLUENCE OF USING DISCRETE CROSS-SECTION VARIABLES FOR ALL TYPES OF TRUSS STRUCTURAL OPTIMIZATION WITH DYNAMIC CONSTRAINTS FOR BUCKLING
The use of continuous variables for cross-sectional dimensions in truss structural optimization gives solutions with a large number of different cross sections with specific dimensions which in practice would be expensiv...
SYSTEM APPROACH TO ASSESSMENT OF THERMAL STRESS OF UNITS OF TRANSMISSIONS
In the article the application of system approach to the study of thermal stress of units of transmissions of transport and technological machines on the example of cardan joints is considered. The authors carried out th...
APPLICATION OF TAGUCHI METHOD FOR THE SELECTION OF OPTIMAL PARAMETERS OF PLANETARY DRIVING GEAR
An experimental research is performed in this study in order to optimize the parameters of planetary driving gear. An orthogonal array and analysis of variance (ANOVA) are employed to investigate the factors: material, m...
INFLUENCE OF THE PVD PROCESS PARAMETERS ON ZNO: AL THIN FILMS
In recent years a growing interest in searching new material for producing Transparent Conductive Layers (TLC) is observed. ZnO:Al thin films are this type material, interesting due to wide range of potential application...