Quality Engineering Procedures Applied to Determine the Weight of Influence of Factors on Microtrigeneration Systems (MCCHP)
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2009, Vol 32, Issue 1
Abstract
Microtrigeneration systems are characterized by simultaneous generation of power, heat and cold for small applications (<50kW) and are designed for reducing GHG and other emission degreases. The cooling generation by absorption or adsorptions of heat is the most sensible stage of mCCHP systems.The paper si based on the global mathematical model for a mCCHP system with thermal prime mover. The conceptual design of an mCCHP and was estabilished the influenece factors over the global efficiency of the system. The weight of influence factors was made using a Quality Engineering procedure (typised orthogonal array. An adequate mathematic model (ANOVA) was used for weight of factor influence prediction, with a view to global efficiency maximization. The simulation results showing signal and noise factors and these results are important for system design, selection of subsystem, selection of materials and optimal regime settings.
Authors and Affiliations
Nelu CAZACU, Nicolae BADEA, Sorin DOBROVICI
Keywords
Related Articles
- EP ID EP658710
- DOI -
- Views 84
- Downloads 0
Recycling Possibilities of Metallurgical Slag
The target of the current metallurgical industry is to recycle and utilize all their by-products. Slags are the important wastes and by-products of metallurgical industry, which have been treated, recycled and used world...
The Influence of the Number of Blades and the Number of Levels on Behavior of the "S" - Rotor Experimental Models
The paper is based on wind tunnel (WT) experiments on experimental models (EMs), vertical axis wind turbines (VAWT), Savonius (SWT, "S" Turbine). The experimental models had the maximum dimensions: height of 0.395 m, and...
Thermodynamic Assesment of The Cu - Ti System in Microalloyed Copper Base Alloys
The correlations made between thermodynamic and kinetic data of the heterogeneous systems provided insight into the alloys properties. Experimental researches presented in this paper refer to the thermodynamics of Cu-Ti...
Aspects of Nitrated Layer Structure for Some Types of Austenite Stainless Steel
The analysis of nitrated layer diffractograms and the structure marked out the presence of complex nitrides combinations layer for all types of steel except for code 6 steel type 2CuMoNiCr200 which because of the very hi...
Thermal Analysis of Inoculated Grey Cast Irons
A research was done to investigate the effect of 0.05…0.25wt.% addition rate of Ca, Zr ,Al – FeSi alloy, in ladle and in-mould inoculation of grey cast irons. In the present paper, the conclusions drawn are based on ther...