Studies on the Renewability of Polymeric Binders for Foundry
Journal Title: Archiwum Odlewnictwa - Year 2012, Vol 12, Issue 3
Abstract
In this paper the results of studies of polymeric binders on the example of the new BioCo2 binder, including the problem of its renewability, are presented. The results of structural studies (FT-IR) for the BioCo2 binder before and after crosslinking, and bending strength tests Rgu fresh and renewed cured molding sands with BioCo2 binder are discussed. The cross-linking binder and curring of moulding sand was carried out by physical agents (microwave radiation, temperature). On the basis of obtained results was shown that it is possible to restore the initial properties of the adhesive of BioCo2 binder. The initial properties of moulding sand can be achieved, after the cross-linking binders and after curing in the moulding sands with bioCo2 binder , by supplementing the moulding sand composition by the appropriate amount of water.
Authors and Affiliations
B. Grabowska, K. Kaczmarska, A. Bobrowski
Keywords
Related Articles
- EP ID EP72693
- DOI 10.2478/v10266-012-0078-x
- Views 120
- Downloads 0
Research on possibility of microwave measurements application for determination of adhesive ingredient content in moulding sand
This paper presents preliminary results of the research on possibility of determination of adhesive material content in classical moulding sands with application of microwave measurements. Presented results have been obt...
Replies to Challenges in the Field of Air Pollution Control in Foundry Plants
The solution of applications for air pollution control in foundries for iron and non-ferrous metals may not only be understood as the observance of requested emission limit values at the stack outlet. An effective enviro...
The influence of remelting parameters of the electric arc and conventional tempering on the tribological resistance of high speed steel HS 6-5-2
The present thesis depicts the results of the research of tribological high speed steel HS 6-5-2 remelted with the electric arc. Steel was remelted with different parameters. The amperage of electric arc was changed, the...
Laboratory grey cast iron continuous casting line with electromagnetic forced convection support
The article describes the construction of a 20 mm diameter grey cast iron ingots continuous casting laboratory line. This line is made of three main units: melting unit (induction furnace), casting unit and the pulling u...
Basics of control system material in iron foundry
The article is taking into account problems of preparing the production of cast-iron casts with reference to correctnesses functioning of processes supplementing, containing elements the system of supply necessary materi...