The Model Tests of Vertical Cylindrical Tanks and a Verification of Numerical Researches
Journal Title: Металлические конструкции - Year 2016, Vol 22, Issue 2
Abstract
This article discusses the results of model tests for vertical cylindrical tanks of 20 thousand m3. Since the loads were sufficiently studied for structures with an aspect ratio of height to width ratio of less than 0.5 comprised in the group, so a series of tests was carried out in a wind tunnel models with different forms, consisting in the group roof. The article discusses the results of the verification of numerical studies to test a model with a flat roof. The results on the project took place in the group will be presented in the next article.
Authors and Affiliations
Hanna Zubenko, Andrey Drozdov
Keywords
Related Articles
- EP ID EP427277
- DOI -
- Views 164
- Downloads 0
Metal multifaceted poles as a base of the urban infrastructures
The article deals with national and the foreign experience of metal multifaceted bent conical poles (tubes) at creation of tower structures directed to a providing of livelihood needs of modern cities. The analytic revie...
Method of Calculation of Maximum Snow Loads on the Horizontal Area on the Territory of the Transcarpathian Region by Rendered Forms
The domestic scientists at the early stage of research revealed that maximum snow loads for the territory of the Transcarpathian region were determined only by the initial data of the snow cover of the III climatic zone,...
Studies of Efficiency of Tie Rod Usage for Masonry Wall Strengthening
In the paper the influence of nontensional horizontal steel tie rods installation in a building perimeter on vertical and horizontal deformations of bearing walls of stone buildings is considered. Buildings of large bloc...
Calculation of the Intense Deformed State of Tank’s Wall Under the Action of the Hydrostatic Load in a Nonlinear Setting with Geometric Imperfections
The work substantiates the necessity of taking into account the specificity of the hydrostatic load when calculating the wall of a tank with geometric imperfections. A step-by-step scheme for loading the tank wall with h...
The Choice of Rational Parameters of Frames of Variable Rigidity, While Using Genetic Algorithm Optimization
The article deals with the use of the genetic optimization algorithm for selecting rational parameters of variable-rigidity metal frames (variable cross-section). An example of the simplest genetic algorithm on the block...